Spray with cold water.
Blood stains on a maroon carpet.
After vacuuming the bits apply cold water and blot until the stain fades or disappears.
Use clean areas of the towel if it is getting too wet and messy.
The first step say pros is to brush or scrape the area to loosen the blood.
Afterward rinse or dab the area with hydrogen peroxide a natural oxidizer.
Note that these are harsher methods that could damage your carpet so remember to always test a small area before applying the solutions to the blood stain.
This will prevent the blood stain from spreading and bleeding onto a larger area of the carpet.
Mix one tablespoon of scent free liquid hand dishwashing detergent with two cups of.
Gently blot until the liquid is completely absorbed.
Mix 1 tablespoon of hand dishwashing liquid with 2 cups of cold water.
Do not use warm or hot water which can set the blood stain permanently into the carpet.
Avoid hot water as it would make the stain set in and way more difficult to remove blood from a carpet.
Especially if your carpet s color is on the lighter side.
If that doesn t work some pros recommend using solutions that vary depending on the carpet material.
Using a mixture of water and ammonia can be an effective way to remove blood stains from a carpet but remember to never use ammonia on woolen carpets.
For this methods mix 1 2 teaspoons of ammonia with water and apply the solution to the carpet.
Using your cloth or rage blot away remember no rubbing the baking soda paste and it will lift the blood stain with it.
You can then follow these few steps to know how to remove blood stains from your carpet.
If the stain is rather large spray the stain from the outside working your way in.
The truth is that if blood is left to dry for more than a few days that stain may never go away.
If you can get to the stain before it sets remove blood stains by pouring full strength white vinegar on the spot.
But may not completely get rid of old stains.
Spray the cold water onto the blood stain.
The solutions mentioned work on newer stains.
Use a wet vac to suck out the remaining moisture if you don t have a wet vac use a dry towel to blot the stain.
Spray the stain with cold water and let it sit a few minutes.
Sponge the blood stain with a clean cloth sodden in the detergent solution to get the blood out of your carpet.
Once you are done drip a little bit of water on the remaining baking soda and blot it up.
Let it soak in for five to ten minutes then blot well with a cloth or towel.
You may be able to fade it out but it may never go away.
